The Besisahar to Bhulbhule section of the Annapurna Circuit runs from about 760 m to about 840 m. Typical time is 1 to 1.5 hours on foot, or 20 to 30 minutes by jeep, rated easy. That is a net gain of roughly 80 m.
Quick facts
- Start: Besisahar, about 760 m
- End: Bhulbhule, about 840 m
- Change: a net gain of roughly 80 m
- Typical time: 1 to 1.5 hours on foot, or 20 to 30 minutes by jeep
- Difficulty: Easy
The route
A short stretch along the Marsyangdi through paddy fields and small villages. Bhulbhule is often the first night stop for walkers.
Altitude and health
This section stays below about 3,000 m, so altitude sickness is unlikely, though heat, humidity and fatigue still matter. Altitudes vary by a few tens of metres between maps and guidebooks.
Tips
It is warm and humid here, so carry sun protection and water.
Common questions
- Can I skip this section? Yes, many trekkers take a jeep from Besisahar to a village further up the road.
- What is Bhulbhule known for? It is a pleasant village and a common first stop on the circuit.
Reverse direction
Walking Bhulbhule to Besisahar is the same trail in reverse. It is usually quicker because it is mostly downhill, but a long descent is hard on the knees, so poles help.
Nearby legs on this route
Plan it
Back to all route information or see the Annapurna Circuit guides.
